Gns3 cisco switches3/25/2023 ![]() ![]() Serial0/1 unassigned YES unset administratively down downįastEthernet2/0 unassigned YES unset up downįastEthernet2/1 unassigned YES unset up downįastEthernet2/2 unassigned YES unset up downįastEthernet2/3 unassigned YES unset up downįastEthernet2/4 unassigned YES unset up downįastEthernet2/5 unassigned YES unset up downįastEthernet2/6 unassigned YES unset up downįastEthernet2/7 unassigned YES unset up downįastEthernet2/8 unassigned YES unset up downįastEthernet2/9 unassigned YES unset up downįastEthernet2/10 unassigned YES unset up downįastEthernet2/11 unassigned YES unset up downįastEthernet2/12 unassigned YES unset up downįastEthernet2/13 unassigned YES unset up downįastEthernet2/14 unassigned YES unset up downįastEthernet2/15 unassigned YES unset up downĪdministrative Trunking Encapsulation: dot1qġ default active Fa2/0, Fa2/1, Fa2/2, Fa2/3 Serial0/0 unassigned YES unset administratively down downįastEthernet0/1 unassigned YES unset administratively down down Interface IP-Address OK? Method Status ProtocolįastEthernet0/0 unassigned YES manual up up Protocol Address Age (min) Hardware Addr Type Interface Sending 5, 100-byte ICMP Echos to 10.1.9.1, timeout is 2 seconds: Have I missed something? Thanks.Ĭisco IOS Software, 3700 Software (C3745-SPSERVICESK9-M), Version 12.4(19), RELEASE SOFTWARE (fc1) I cannot ping and I cannot even ping 10.1.9.1, the VLAN 1 IP. ![]() ![]() I then reconfigured and connected the PC instance via a layer 2 port f2/0 which is part of the 16port switch module. I have created a PC instance and connecting to f/0/0 which is a layer 3 port, I can connect via layer 3 IPs. Am using GNS3, and have the 16port switching module. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |